Saturn S300 Series Service Manual page 12

Safety
Equipment Safety Guidelines
WARNING: Always observe the following safety guidelines when
installing, operating, servicing, or maintaining the
printer and associated equipment.
Comply with Electrical Codes
Shutdown the power before opening printer door;
Do not insert tweezers, screw driver or any steel material into ink
ejection hole at the end of printhead. When the printer is ready to
print, a high voltage (approximately 6 kV) is applied to the
deflection electrode section in the printhead.
Exercise caution to avoid electric shock, injury, and fire.
Avoid Breathing Exhaust Vapors
During operation, the printer exhausts vapors through the muffler.
These vapors may be flammable and present a healthy hazard. For
these reasons, do not allow the exhaust to be confined to an area
that does not have proper ventilation or near a source of ignition.
Printer exhaust fumes are generally heavier than air, so keep all
sources of ignition away from low areas where fumes may travel or
accumulate. Ensure that no welding operations are performed
within 5 m of the printer.
Do Not Remove Warning Labels
Do not, under any circumstances, remove or obstruct any warning
or instruction labels in the printer.
WARNING: Do not place the printer in an explosive atmosphere.
If emergency occurs, press the power switch to turn off the power.
Use the printer at the temperature with 0—40°C and relative
humidity of 30-90%, or will cause fault to printer.
Do not mix different types of ink together, or will cause printer fault
Printer should link to ground well, or will affect printing.
2-5