Saturn S300 Series Service Manual page 51

Installation
Cable, wire, and construction material manufacturers usually require printing from the first meter at
any time, but this requirement is random and unpredictable. When deciding reset serial number to 1,
resetting serial number too many times may cause miss opportunity to reset.
Therefore, S420 Serial printer add a special function as "Quick Reset Serial Number". When printing,
you just have to press Shift+Del together. Then, there comes out a quick reset dialogs. Press on
Enter, and current serial number will be reset to 1.
Other Concerning Points: (1) For 66 and 53 micro printer (Include S420P), the message height
should not be lower than 80, or the printing message will be missing.
Decrease the value of "Change SPEC" to further lower down the
message height.
(2) The value of "Change SEPC" for 53 micro should not be higher
than70, or the printing message will be missing.
(3) For 40 micro printer, the ink pressure is set at 46Psi, the message
height should not be lower than 40, or the printing message will be
missing. Decrease the value of "Change SPEC" to further lower down
the message height.
(4) The "Frequency Multiple" in <Encoder Setup> should be 1 to the
greatest extend, or there will be a error in Length counter.
(5) After changing parameters, press on Shift + F1 to quick save.
4-16