Saturn S300 Series Service Manual page 50

Installation
5. Reset Serial Number
CAUTION:
The name of the serial number is built up by the system, and it
cannot be changed by yourself.；
If you enter wrong setting during parameter setup, press
<Cancel> to come back to the old value, and then enter the new
setting again.
If you want to change the setting of the serial number inserted,
move the cursor to the "serial number" block, and this block
will reverse video in the "Message Edit Zone" of the screen,
then select <serial number>, set up the parameter of the serial
number again and the changed serial number information you
setup will be displayed in the "Message Edit Zone".
If you just want to change the current value of the serial number,
it is suggested to choose "Reset Serial Number", which can be
used in the printing. The procedure will display as below:
This function is only to change the current value of serial number, but
cannot change other parameter of the serial number. The steps of
restoring serial number is as below;
1. Enter<Message Edit -2>, select <Reset Serial Number>, it displays as
below:
Status:
Printer is ready
2007 / 12/ 13
12 : 24 : 36
0070
Name
Change Start Value
0
1
Ok (F1)
2. Use <Direction Key> to move the Parameter Setup Zone to the
position of the serial number that needs to be changed, and the
serial number in the zone will be white.
3. Use <Adjust Key> to Change "Start" Value and choose "yes", and
then use right <Direction Key> to move to the "Current Value" to
insert a new value you want.
4. Repeat the steps to change other current values of the serial
number.
5. After changing choose "Ok" to finish the operation.
CAUTION: After "Reset Serial Number" changing, the times of
"repeat times" (when it is not 1) of this serial number, it will be counted
again.
Reset Serial Number
2007 / 12 / 13 12:00
Current Value
yes
no
Exit (F3)
Cancel (F2)
Current Flow Time: 4200
4-15
0070
076