Saturn S300 Series Service Manual page 122

Maintenance
Procedure 2
Prime make-up or cleaning solution into
the flush system
Make sure there is
enough fluid in the
make-up bottle and
the "printer is off".
Turn the make-up
tank cap clockwise to
take off it.
Use a container to
hold the pipe with
yellow
(Refer to picture
below)
Switch
power supply.
Figure 6-12. Auto Flushing (Procedure 2)
mark.
on the
Caution: Refer to Ink Maintenance Flow Charts on
Enter <System
Maintenance>, select
"Manual Control".
Open PUMP, Make-up
Solenoid in turn, the
make-up will flow out
continuously.
Close
Solenoid, and then
open
Solenoid.
until ink
continuously.
Exit "Manual control"
to stop priming
make-up.
Put on and tighten
the ink tank cap
again
Return to
Figure 6-10.
page 6-16
maintenance procedures.
6-19
Make-up
Cleaning
Close it
flow out
before performing ink