Saturn S300 Series Service Manual page 138

Trouble Shooting
What Happens When a
Fault Occurs?
What is Need
When a Faults Occurs?
Common phenomenon
and Solution for Faults
High voltage fault (refer to page 7-10)
Ink overfilled fault (refer to page 7-10)
Communication fault (refer to page 7-10)
When a fault occurs, the following happens:
The fault message will be displayed in the "Fault Report
Zone" of the screen and the red LED on the <Ink Jet Key> will
be lighten.
The fault message of which kind will be displayed at the
"Fault Report Zone" of the screen. Relative engineer should
maintain the printer and clear the alarm status. The faults or
warning should be saved on the faults recorder in the
<System setup> for the service engineer.
If several faults occur at the same time, the fault warning will
be display at the screen until the trouble been solved, and
the four-minute shutdown sequence begins (without "Auto
Flush").
If the warning occurs, printer could continue to work.
If
automatically.
If a panic fault occurs, the printer will shutdown immediately
(shut off all the solenoids).
to Do
When a fault occurs, please refer to the "Cause/Solution" table
for that particular fault and try the solutions provided to solve the
problem.
CAUTION: After the Panic fault occurred, the maintainance will
be needed immediately, you need try to solve the problem to
avoid the remained ink in the recovery tube clogged.
The following content covers all the faults of the printer. Every
fault has detailed consequence and solution. Please use this
information to solve the problems.
the normal fault
7-5
occurs, printer will shutdown
Aug. 2008