Saturn S300 Series Service Manual page 84

INK JET PRINTER OPERATION
Message INV/REV
Encoder Setup
It is used to control the direction of print (inverse or reverse).The
procedures as below:
1. Enter <Print Setup-2>, select <Message INV/REV>, it displays as
below:
Status:
Printer is ready
Saturn Technologies Co. Ltd
Message Reverse
Message Invert
Ok
2. Use up/down <Direction Key> and right/left <Adjust Key> to
change the status of "Reverse" and "Invert" respectively to meet
the production demand;
3. Press <OK> to confirm the settings.
It must be installed an encoder to keep the print speed synchronizing
with the product line if the line speed is unstable or needed to be
changed. The procedures of setup as below:
1. Enter <Print Setup-3>, select <Encoder Setup>. It displays as
below:
Status:
Printer is ready
Saturn Technologies Co. Ltd
Encoder Status
Frequency Divide
Frequency Multiple
Ok (F1)
2. If the Frequency Divide and frequency multiple can not be
selected, please check if FCU frequency control unit has been
installed correctly. (See CAUTION of Chapter Four 4-7page)
5-32
Message Inv / Rev
2007 / 12 / 13 12:00
ABCD
On
On ABCD
Current Flow Time: 4200
Encoder Setup
2007/ 12 / 3 12:00
Off
1 (1~31)
1 (1~31)
Exit (F3)
Cancel (F2)
Current Flow Time: 4200
Exit