Saturn S300 Series Service Manual page 52

Installation
Set up the Printer
Final Installation Topics
Tools and Supplies
Needed
Flush the system and
Load the Ink
Your S420 printer is now ready for its final installation set-up.
The final set up includes:
tools and supplies needed
calibrating the ink flow time and set it
loading with the ink and make-up
adjusting ink stream and breakoff
The following are essential for proper printer set-up:
SATURN ink
SATURN make-up fluid
Wash Pan (Service Tray)
Printhead Holder & Thumb Screw
Magnifier Glass
Selection of hand tools
CAUTION: Instructions for flushing the system with make-up
fluid and loading it with ink, as well as the following calibration
procedure, are found in Chapter 6, Maintenance.
WARNING: Make certain to ground the service tray to the printer,
and install the printhead into the service tray. Failure to properly
ground the service tray and printhead when using flammable ink
may cause fire due to static discharge.
WARNING: Ensure that the work area is well-ventilated.
WARNING: The printer must be flushed with make-up fluid
before ink is loaded into the system for the first time. The system
must also be flushed with make-up when it is brought back
on-line from storage.
Follow the System Flush procedure (Chapter 6, Maintenance) to
calibrate flow time and load the system with ink.
Be sure to include these steps:
1. Prepare the printer
2. Flow time calibration
3. Load the ink
4. Load the make-up fluid
5. Print head temperature calibration and setup
6. Ink stream calibration
7. Ink stream breakoff adjustment
4-17