Saturn S300 Series Service Manual page 128

Maintenance
Procedure 5
Procedure 8
Procedure 5
Load Fluid into the Printer
Nozzle Drive Set-up
(Ink, Make-up or cleaning solution)
Flushing Viscosimeter
Start
Place ink tank
into a beaker
which with 150
Press inkjet key to
start up printer.
inside (r
Edit the message
Select "Manual
you want to print.
Maintenance>.
Set <Nozzle Drive>
at 1 and
Open
increase until
AGITATION
breakoff comes
into view in charge
tunnel window.
Close
Gradually
PUMP in
increase nozzle
one minut
drive level until
the ink breakoff
reverses direction
and begins to
move toward the
front end of the
Printhead. (The
point at which it
reverses direction
is foldback).
Figure 6-18. Nozzle Drive Set-up (Procedure 8)
ml make -up
efer to
Figure 6-25,
Page 6-15)
Lower nozzle drive
below foldback and
Control" in
determine the print
<System
window (nozzle
drive range that
yields good print
quality) using the
following criteria:
PUMP,
in turn.
AGITATION,
turn after
e later.
*Refer to page 6-28, Print Quality
(Nozzle Drive Set-up Procedure) for a
more detailed explanation.
Use a container to
hold the pipe with
blue mark. (Refer to
Figure 6-12)
Satellites, if
present, are
forward-merging.
Number of
satellites is three
or fewer.
Breakoff point
lies within
charge tunnel.
Print quality is
acceptable*.
WARNING: Refer to Ink Ma
Charts on page 6-16 before
WARNING: Refer to Ink Maintenance Flow Charts
performing ink maintenance
procedures.
on page 6-16 before performing ink
maintenance procedures.
6-25
Set the nozzle drive
between the upper
and lower extremes
of good print
quality (determined
previously), and
with the fewest
number of
satellites.
Adjust positive air
flow to
0.5-1.5 SCFH
(14.16-42. 47 L/hr).
Whether
the printing
is good?
Yes
Complete the setup.
Return to
production.
intenance Flo w
No