Saturn S300 Series Service Manual page 119

Maintenance
General Printer
Maintenance
Hydraulic Maintenance
Flow Charts
Fluid
If you need to do any of these:
flush the hydraulic system
install a new printer
remove contaminated ink
store the printer
Perform the procedures in the order shown in Figure 6-10 on page
6-18.
Figure 6-10 is a complete flow chart which covers the conditions
under which you perform the maintenance procedures.
CAUTION: Some procedures are repeated for different
fluid types: PROCEDURE 1 for loading Ink and for loading
Make-up Fluid, for example.
Refer to Figure 6-10 for the procedure to complete in each
situation, and the page number to turn to for that particular
procedure. Refer to Table 6-5 for a list of each of the procedures
found in Figure 6-10, and where to turn in this chapter to find that
procedure.
Procedure Name
Prime Fluid
Auto Flush
Flushing System
Drain Fluid
Flushing Viscosimeter
Flow Time Calibration
Printer Long Term Storage
Nozzle Drive Set-up
Changing new type of Ink
Table 6-5. Ink Maintenance Flow Charts
Procedure
6-16
Page Number
Number of Flow Chart
1 6-18
2 6-19
3 6-20
4 6-21
5 6-22
6 6-23
7 6-24
8 6-25
9 6-26