Saturn S300 Series Service Manual page 121

Maintenance
Procedure 1
Load Fluid into the Printer
Place fluid in the left
compartment; ensure
that make-up fluid is
Keep the print head
towards
better
container at the down
side.
Figure 6-11. Prime Fluid into the Printer (Procedure 1)
Start
side replenishment
loaded on the right
side.
Take off the print
head cover (Figure
6-2).
ground,
with a
Switch on
The power supply
Select "Prime
Fluid" in <System
Maintenance>.
Reverse the main
filter. (Ensure the
output connector
at the upside)
Turn regulator
knob clockwise to
set ink pressure at
2.6-2.8.
"Prime Fluid" will
stop
minuets.
Return to
Figure 6-10.
WARNING: Refer to Ink Maintenance Flow
Charts
performing
procedures.
6-18
after 4
on page 6-16
ink maintenance
before