Saturn S300 Series Service Manual page 16

Safety
Shutdown without Auto Flush
Print Key
Press the
this shutdown frequently in a short period of time will cause surplus adding of make-up to the
system. If the shutdown time is less than 30 seconds, you should perform the quick shutdown
procedure.
Quick shutdown: If the shutdown time is less than 30 seconds you may perform the quick
Caution:
① After finishing maintenance on the printer using "shutdown without auto flush"
it is important to note that if you intend not to use the printer for some time you
must perform the normal shutdown procedure to make sure that the ink recovery
tube is perfectly clean.
② After finish the maintenance, if need to start up again, manually cleaning the
nozzle procedure is needed to perform to make sure the ink stream perfectly
recover to the gutter.
for 2 seconds, the printer will start to shutdown with a "system cleaning". Using
shutdown procedure to avoid surplus adding of make-up. This procedure will
shorten shutdown time. Shutdown without auto flush is used normally for
maintenance purposes only.
Press "Print Key", green LED will off, and status area will indicate "Printer is
ready";
System Status:
Printer is ready
Ink On/Off
Enter "System Maintainence-1", select "Ink On/Off", status area will display
"Printer is Shutting down H.V.", "Printer is Shutting down". When the ink in
recovery tube is drain out, you can turn off the switch to maintain the printer.
Print Status
(Green LED)
System Maintainence-1
2007/12/26 12:00
H.V. On/Off
Current Flow Time:
2-9
Print Test