Wiring For I/O Connectors (Mil Connector) - Panasonic FP-M Hardware Manual

5) Wiring for I/O connectors (MIL connector)

• There are the following 4 methods for wiring to the I/O connectors (MIL connectors) on each board.
(BATT.)
EPROM EPROM
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
9600
19200
CT-2 connector terminal
RT-2 relay terminal
Wire-press socket
Flat cable connector
• The I/O connector on the board and the connector on
the CT-2 connector terminal can be connected using a
cable. Input wiring and transistor output wiring is easy.
• The terminals are connected using a cable. This
eliminates the work required for wiring.
• Control of up to 2 A is possible using this terminal, and
maintenance and inspection such as relay replacements
are easy.
• A twisted wire (0.2 to 0.3 mm-squared) can be
connected directly.
• The wiring can be done easily using wires with the
covers on, and a pressure welder.
• Wiring mistakes can also be corrected easily.
• Wiring can be done easily using a flat cable with a
connector on only one end.
4-3. Wiring
55