M1T-Eo Type - Panasonic FP-M Hardware Manual

4) M1T-EO type



4 Indicators

for output

connector B
(LED)

1 Expansion power supply connector:
2 3 Output connector A (34-pin)
and B (34-pin):
4 Indicators for output connector B (LED):
5 Expansion connector:
6 Output address setting switches:
7 Indicators for output connector A (LED):
5 Expansion connector
5 1 5
SW2 SW1
3 Output connector B
Connected to the control board, the power is supplied to the
expansion board through this.
Connects the output field devices (e.g., solenoid).
MIL connector is used. Use a wire-press socket and flat cable
connector for wiring.
Indicates the output ON/OFF states.
Connects the control board with the internal circuit.
The output addresses for the expansion boards are set using these
switches.
Refer to page 39, "3-2. I/O Allocation of Expansion Boards", for
details.
Indicates the output ON/OFF states.
6 Output address setting switches
1
2 Output connector A
SW1: Output address setting switch for output connector A
SW2: Output address setting switch for output connector B
2-2. Parts Terminology
7 Indicators
for output
connector A
(LED)
1 Expansion power
supply connector
31