Parts Terminology - Panasonic FP-M Hardware Manual

3. Parts Terminology

6 Expansion connector

0
1
2
3

4
5
6
7 
5 Station monitor LEDs
8
9
A

B
C
D
E

F
1 Expansion power supply connector:
2 RS485 interface:
3 Operation mode selector:
(See following page.)
4 Selector for station monitor LEDs:
5 Station monitor LEDs:
6 Expansion connector:
7 Operation monitor LEDs:
(See following page.)
7-6. FP-M Transmitter Master Board (MEWNET-TR)
IN
1 2 3 4 5 6 7 8
OUT
+ –
FG
2 RS485 interface
3 Operation mode selector
4 Selector for station monitor LEDs
Supplies power to the FP-M transmitter master board (MEWNET-
TR) through the expansion power supply cable.
Interface for MEWNET-TR communications.
Selects the MEWNET-TR communication conditions and sets the
I/O addresses.
Selects condition of station monitor LEDs (input or output).
INPUT position:
OUTPUT position: Status of slave station (FP I/O transmitter
LEDs that monitor the slave stations connected to the FP-M
transmitter master board (MEWNET-TR).
Connected to the control board.
Indicate the operation and communication status of the
MEWNET-TR system.
7 Operation monitor LEDs
POWER
COM.
ALARM
1 Expansion power
supply connector
Status of slave station (FP I/O transmitter
units) input type is indicated by LEDs.
units) output type is indicated by LEDs.
163