Panasonic FP-M Hardware Manual page 64

4-3. Wiring
CT-2 connector terminal
• Select a CT-2 connector terminal and a cable for the CT-2 connector terminal with the correct number of pins for
the connector on each board.
• Use a terminal block for M3 size screws for the connector on the CT-2 connector terminal.
Connector example 1: C20T control board
• The I/O connector for the C20T control board has 20
input pins and 16 output pins.
Use:
- CT-2 connector terminals: CT2-20 (for 16 pins and
- Cable for CT-2 connector terminal: 16 and 20 pins
Connector example 2: C32T control board
• The I/O connector for the C32T control board has 30
input pins and 34 output pins.
Use:
- CT-2 connector terminals: CT2-30 (for 30 pins) and
- Cable for CT-2 connector terminal: 30 and 34 pins
56
20 pins)
CT2-34 (for 34 pins)
Cable for CT-2
connector terminal
(34P to 34P)
C20T control board
RUN REMOTE PROG.
9600
19200
Cable for CT-2
connector terminal
(16P to 20P)
CT-2 connector terminal (CT2-20)
C32T control board
EPROM EEPROM
V0 V1
9600
19200
CT-2 connector
terminal
(CT2-34)
(BATT.)
EPROM EPROM
RUN PROG. ERR ALARM.
Cable for CT-2
connector terminal
(20P to 20P)
(BATT.)
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
Cable for CT-2
connector terminal
(30P to 30P)
CT-2 connector
terminal
(CT2-30)