Panasonic FP-M Hardware Manual page 207

Address Name
R9012 Scan pulse relay
R9013 Initial ON relay
R9014 Initial OFF relay
R9015 Step ladder initial
ON relay
R9018 0.01 s clock pulse
relay
R9019 0.02 s clock pulse
relay
R901A 0.1 s clock pulse
relay
R901B 0.2 s clock pulse
relay
R901C 1 s clock pulse
relay
R901D 2 s clock pulse
relay
R901E 1 min clock pulse
relay
R9020 RUN mode flag
R9026 Message flag
R9027 Remote mode flag
R9029 Forced flag
R902A Interrupt flag
R902B Interrupt error flag
R9032 RS232C port
selection flag
Turns ON and OFF alternately at each scan.
Turns ON only at the first scan in the operation.
Turns OFF from the second scan and maintains the OFF state.
Turns OFF only at the first scan in the operation.
Turns ON from the second scan and maintains the ON state.
Turns ON only in the first scan of the process the moment step ladder
process is started.
Repeats ON/OFF operations in 0.01 s cycles.
(ON : OFF = 0.005 s : 0.005 s)
Repeats ON/OFF operations in 0.02 s cycles.
(ON : OFF = 0.01 s : 0.01 s)
Repeats ON/OFF operations in 0.1 s cycles.
(ON : OFF = 0.05 s : 0.05 s)
Repeats ON/OFF operations in 0.2 s cycles.
(ON : OFF = 0.1 s : 0.1 s)
Repeats ON/OFF operations in 1 s cycles.
(ON : OFF = 0.5 s : 0.5 s)
Repeats ON/OFF operations in 2 s cycles.
(ON : OFF = 1 s : 1 s)
Repeats ON/OFF operations in 1 min cycles.
(ON : OFF = 30 s : 30 s)
ON while mode of the programmable controller is set to RUN.
OFF while mode of the programmable controller is set to PROG.
F149 (MSG)
ON while the
ON while mode selector of the FP-M control board is set to REMOTE.
ON during the forced ON/OFF operation.
ON while external interrupts are enabled.
ICTL
Refer to the instruction in the FP-M/FP1 Programming Manual.
Turns ON when an interrupt error occurs.
ON while the RS232C port is set to GENERAL (K2) in the system register 412.
C types (C20RC/C20TC/C32TC) only.
8-6. Special Internal Relays
Description
instruction is executed.
199