Install The Memory (Rom); How To Program Rom; Writing A Program To The Memory (Eprom) Via Master Memory (Eeprom) With A Commercially Available Rom Programmer - Panasonic FP-M Hardware Manual

2. Install the Memory (ROM)

• Set the same mode between memory (ROM) type
and memory selector.
• Turn OFF the power of the FP-M control board
before installing or removing the memory (EPROM)
and master memory (EEPROM).
• Put the memory on the user memory socket, align
the pins of the memory with the user memory socket
holes and insert correctly.
• Attach an opaque sheet onto the window on the
memory (EPROM) before use. If the opaque sheet is
not attached, light may cause problems.
• When removing the memory (EPROM) and master memory
(EEPROM) from the user memory socket, use of an IC
EXTRACTOR is recomended. Note that the surface of the FP-M
control board might be damaged by using a screwdriver.

3. How to Program ROM

• Using a commercially available ROM programmer, the contents of RAM on the FP-M control board can be written
to the memory (ROM).
• The following types of memory (ROM) are available:
- Memory (EPROM):
- Master memory (EEPROM): AFP5207 [28C256 type or equivalent]
1) Writing a program to the memory (EPROM) via master memory (EEPROM) with a
commercially available ROM programmer
Necessary tools
• Memory (EPROM): AFP5202 [27C256 type or equivalent]
• Master memory (EEPROM): AFP5207 [28C256 type or equivalent]
• Commercially available ROM programmer: We recommend Aval Data Corporation's PECKER 11
• Programming tools
- FP-M personal computer cable (for NPST-GR): AFC8513 (3 m/9.843 ft.)
- RS232C interface adapter: See page 84.
- Commercial computer: IBM PC-AT or 100 % compatible machine
- NPST-GR Software Ver. 3: AFP266538
- FP-M peripheral cable: AFC8521 (1 m/3.281 ft.), AFC8523 (3 m/9,843 ft.)
- FP Programmer II: AFP1114
AFP5202 [27C256 type or equivalent]
Memory for storing programs. Writing is done with a commercially available ROM
programmer.
Memory for copying programs. Writing is done with a master memory attached to
the FP-M control board.
Main memory: 550 KB or more free
EMS: 800 KB or more free
Hard disk space: 2 MB or more required
Operating system: MS-DOS Ver. 3.30 or later
Video mode (display mode): VGA
Opaque sheet
User memory socket
(EPROM/EEPROM)
Notchs
IC EXTRACTOR
MODEL GX-6
Sun hayato Corp.

5-7. How to Program ROM

Memory (ROM)
FP-M
control board
107