M1T-Ei Type - Panasonic FP-M Hardware Manual

2-2. Parts Terminology

3) M1T-EI type



4 Indicators

for input

connector B

(LED)
1 Expansion power supply connector:
2 3 Input connector A (40-pin)
and B (20-pin):
4 Indicators for input connector B (LED):
5 Expansion connector:
6 Input address setting switches:
7 Indicators for input connector A (LED):
30
5 Expansion connector
5 1 5
SW2 SW1
3 Input connector B
Connected to the control board, the power is supplied to the
expansion board through this.
Connects the input field devices (e.g., limit switch).
MIL connector is used. Use a wire-press socket and flat cable
connector for wiring.
Indicates the input ON/OFF states.
Connects the control board with the internal circuit.
The input addresses for the expansion boards are set using these
switches.
Refer to page 39, "3-2. I/O Allocation of Expansion Boards", for
details.
Indicates the input ON/OFF states.
6 Input address setting switches
1
2 Input connector A
SW1: Input address setting switch for input connector A
SW2: Input address setting switch for input connector B
7 Indicators
for input
connector A
(LED)
1 Expansion power
supply connector