M1T-E Type - Panasonic FP-M Hardware Manual

2) M1T-E type




4 Output
indicators

(LED)

1 Expansion power supply connector:
2 Input connector (40-pin):
3 Output connector (34-pin):
4 Output indicators (LED):
5 Expansion connector:
6 I/O address setting switches:
7 Input indicators (LED):
5 Expansion connector
6 I/O address setting switch
5 1
3 Output connector
Connected to the control board, the power is supplied to the
expansion board through this.
Connects the input field devices (e.g., limit switch).
MIL connector is used. Use a wire-press socket and flat cable
connector for wiring.
Connects the output field devices (e.g., solenoid).
MIL connector is used. Use a wire-press socket and flat cable
connector for wiring.
Indicates the output ON/OFF states.
Connects the control board with the internal circuit.
The I/O addresses for the expansion boards are set using this switch.
Refer to page 39, "3-2. I/O Allocation of Expansion Boards", for
details.
Indicates the input ON/OFF states.
2 Input connector
2-2. Parts Terminology
7 Input indicators
(LED)
1 Expansion power
supply connector
29