Operation Procedure - Panasonic FP-M Hardware Manual

2. Operation Procedure

• After installation and wiring, perform a trial operation according to the following procedure.
START
1. Power ON
2. Programming
3. Check output wiring
4. Check input wiring
5. Trial operation
6. Program correction (debug)
7. Program storage
END
• Before turning the power ON, check the items on the previous page.
• After the power is ON, does the PROG. LED turn ON correctly?
• A program can be written using NPST-GR Software or FP Programmer II.
• Check the program using the self-diagnostic function of the programming
tool.
Note:
• Using the FP Programmer II, be sure to make the program clear
before input.
• Check the output wiring by using the forced output function.
• Check the input wiring by watching the ON/OFF status of the input
indicators.
• When the mode selector is switched from PROG. to RUN, does the
operating LED turn ON ?
• Check the operation of the program.
• If there is a problem in the operation, check the program using the
monitoring function of the programming tool.
• Rewrite the program.
• We recommend that the created program be saved onto a floppy disk or
EPROM/EEPROM.
5-2. Before Turning the Power ON
79