Panasonic FP-M Hardware Manual page 236

8-12. Modem Communication
How to set system registers 412, 413, 416, and 415
• Using NPST-GR Software version 3.1
<If you are using MENU 1 screen type>
Open [NPST MENU] by pressing
select "PLC CONFIGURATION" to skip to the
[PLC CONFIGURATION] subwindow.
In the [PLC CONFIGURATION ] subwindow,
select "1. SYSTEM REGISTER".
Open the [SYSTEM REGISTER]-[SET RS232C] window by pressing
The following is displayed:
412 RS232C PORT SELECTION
413 RS232C SEND FORM
414 RS232C BAUDRATE
416 RS232C MODEM CONNECTION
Open the [SYSTEM REGISTER]-[COMPUTER LNK] window by pressing
following is displayed:
415 UNIT NO.
After setting, save the status of the system registers by pressing
Note:
• * Set the character length, parity check, and stop bit so that the total number of bits used to send a
character add up to 10 bits.
EXAMPLES
Start bit Character bits
1 +
1 +
1 +
228
, and then
Esc
DATA LENG*
PARITY CHK
STOP BIT
TERMINATOR
HEADER
Parity bit
7 + 1 +
7 + 0 +
8 + 0 +
<If you are using MENU 2 screen type>
Open [NPST FUNCTION MENU] by pressing
, and then select "R. SYSTEM REGISTER".
Esc
[ UNUSED / COMPUTER LNK / GENERAL ]
..................................Select COMPUTER LNK.
[ 7BIT / 8BIT ].........Select 7-bit or 8-bit.
[ NONE / WITH ] ....Select with or without parity check
[ ODD / EVEN ] ......Select ODD or EVEN when the parity,
[ 1BIT / 2BIT ].........Select 1-bit or 2-bit.
[ CR / CR+LF / CR / ETX ]
[ NO STX / STX ]
Terminator and header settings are ignored in the computer
link mode.
[ 1 ]...........................This setting is ignored when the
[ ENAB / DISA ]......Select "ENAB".
[ 1 ]...........................Select K1 though K32.
.
F1
Stop bits Total
1 = 10 bits
2 = 10 bits
1 = 10 bits
+ together.
Shift
F8
above, is selected.
modem connection is selected.
+ together and the
Shift F7