Panasonic FP-M Hardware Manual page 196

8-5. System Registers
How to set the system registers
The system registers can be set by a programming tool.
• Using NPST-GR Software Ver. 3.1
1 Set the mode of the programmable controller to PROG.
2 Open the [SYSTEM REGISTER] window using the following procedure:
<If you are using MENU 1 screen type>
Open [NPST MENU] by pressing
select "PLC CONFIGURATION" to skip to the
[PLC CONFIGURATION] subwindow.
Select "1. SYSTEM REGISTER" in the
[PLC CONFIGURATION] subwindow.
Set the mode of the NPST-GR Software to ONLINE by pressing
Open the window you want to set by pressing one of
and change the value in the system register.
3 After setting, press
• Using the FP Programmer II
1 Set the mode of the programmable controller to PROG.
2 Press the keys on the FP Programmer II, as shown on the right.
3 Input the system register address referring to the example and read the current
settings.
EXAMPLE:
When reading system register 400, press the keys as shown on the right.
4 Input new settings referring to the example.
EXAMPLE:
To input K1, press the keys as shown on the right.
You can also input new settings in hexadecimal by pressing
inputting the setting value.
Note:
• The revised settings of the system register become effective soon after the revision. However, in case of
changing the modem compatibility, the revised setting become effective after the power is turned from
OFF to ON.
188
, and then
Esc Esc
and type " " to save the revised settings to the programmable controller.
F1 Y
<If you are using MENU 2 screen type>
Open [NPST FUNCTION MENU] by pressing
, and then select "R. SYSTEM REGISTER".
Esc Esc
+ together.
Ctrl Esc
through or
F6 F10 Shift
ACLR
(HELP)
CLR
(HELP)
(BIN)
before
CLR
K/H
+ through ,
F6 F10
(–)
5 0 ENT
OP
READ
4 0 0
Setting value
(BIN)
1 WRT
K/H
(BIN) (BIN)
1 WRT
K/H K/H