Panasonic FP-M Hardware Manual page 116

5-7. How to Program ROM
Procedure
[FP-M RAM → master memory (EEPROM) → ROM programmer memory → memory (EPROM)]
1. Turn OFF the power of the FP-M control board.
2. Attach the master memory (EEPROM) to the
FP-M control board. Set the memory selector to
EEPROM mode.
3. Set the mode selector of the FP-M control board
to PROG. mode and then turn ON the power of
the FP-M control board.
4. Transfer the contents of RAM to the master
memory (EEPROM) using programming tools
(NPST-GR Software or FP Programmer II) as
shown below.
• Using NPST-GR Software Ver. 3.1
1 In the ONLINE mode, press the
to display the [NPST MENU] window.
2 Select the PROGRAM MANAGER
option from the NPST menu.
3 Select the 7. COPY PROGRAM
BETWEEN ROM & RAM option from
the [PROGRAM MANAGER] menu.
4 Press
.
F1
When the [COPY RAM TO ROM] window
opens, the contents of RAM will be loaded from
RAM to ROM.
• Using FP Programmer II
1 Press the keys in the sequence shown right.
2 The contents of RAM will be loaded into the
attached ROM.
5. Turn OFF the power of FP-M control board. Detach
the programmed master memory (EEPROM) from the
FP-M control board.
6. Attach the master memory (EEPROM) to
the ROM programmer. Transfer the
contents of master memory (EEPROM) to
ROM programmer memory.
7. Replace the master memory (EEPROM) on the
ROM programmer with the memory (EPROM).
Write the contents of the ROM programmer
memory to the memory (EPROM).
Notes:
• If you want to write the contents of RAM on the FP-M control board to a master memory (EEPROM), be
sure to set the mode selector to PROG. before turning ON the power.
• When using a commercially available ROM programmer to write to the master memory (EEPROM) or the
memory (EPROM), refer to the manual that comes with it for operation procedure and settings.
108
Master memory
(EEPROM)
key
Esc
[COPY RAM TO ROM]
PROGRAM & SYSTEM REGISTER WILL BE TRANSFERRED
FROM RAM TO ROM.
F1 :
(–)
ACLR
OP
9600
19200
ROM
programmer
memory
Memory
(EPROM)
Memory selector
EPROM EEPROM
EPROM EEPROM (BATT.)
V0 V1
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
9600
19200
FP-M control board
EPROM EEPROM (BATT.)
V0 V1
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
9600
19200
FP-M control board
NO.=[ 0 ] RT =[ 1 ]
EXECUTE.
9 9 ENT WRT
EPROM EEPROM (BATT.)
V0 V1
RUN PROG. ERR ALARM.
RUN REMOTE PROG.
FP-M control board
Commercially available ROM programmer
ROM
programmer
memory
Mode selector
RUN REMOTE PROG.
RAM
HOME
Master memory
(EEPROM)
Master memory
(EEPROM)