Click the Clear Time Range to remove all the entries.
To learn more about the D-Link Green Technologies, go to
D-Link Discovery Protocol
This window is used to configure D-Link discovery protocol.
To view the following window, click Management > D-Link Discovery Protocol as shown below:
The fields that can be configured are described below:
Parameter
D-Link Discovery
Protocol State
Report Timer
From Port / To Port
State
Click the Apply button to accept the changes made for each individual section.
ZTP Settings
This window is used to configure Zero Touch Provisioning (ZTP) settings.
To view the following window, click Management > ZTP Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 3-49 D-Link Discovery Protocol window
Description
Click to enable or disable the D-Link Discovery Protocol function globally.
Select the interval between two consecutive report messages.
Select the appropriate port range used for the configuration.
Select to enable or disable the D-Link Discovery Protocol function on the specified
ports.
http://green.dlink.com/
65
for more details.