D-Link DGS-3000 Series Reference Manual page 128

Click the Select All button to select all the ports for configuration.
Click the Clear All button to unselect all the ports for configuration.
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
MLD Snooping Rate Limit Settings
Users can configure the rate limit of the MLD control packet that the switch can process on a specific port or VLAN in
this page.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Rate
Limit Settings as shown below:
The fields that can be configured are described below:
Parameter
Port List
VID List
Rate Limit
Click the Apply button to accept the changes made for each individual section.
Click the Find button to locate a specific entry based on the information entered.
Click the Edit button to re-configure the specific entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
MLD Snooping Static Group Settings
This page used to configure the MLD snooping multicast group static members.
To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Static
Group Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
configuration.
Figure 4-59 MLD Snooping Rate Limit Settings window
Description
Enter the Port List here.
Enter the VID List value here.
Configure the rate limit of MLD control packet that the switch can process on a
specific port/VLAN. The rate is specified in packet per second. The packet that
exceeds the limited rate will be dropped. Select the No Limit check box to lift the rate
limit requirement.
119