Pppoe Circuit Id Insertion Settings; Smtp Settings - D-Link DGS-3000 Series Reference Manual

PPPoE Circuit ID Insertion Settings

This window is used to configure the PPPoE circuit ID insertion function.
To view this window, click Network Application > PPPoE Circuit ID Insertion Settings as shown below:
The fields that can be configured are described below:
Parameter
PPPoE Circuit ID
Insertion
From Port / To Port
State
Circuit ID
Click the Apply button to accept the changes made for each individual section.

SMTP Settings

Simple Mail Transfer Protocol (SMTP) is a function of the Switch that will send switch events to mail recipients based
on e-mail addresses entered in the window below. The Switch is to be configured as a client of SMTP while the server
is a remote device that will receive messages from the Switch, place the appropriate information into an e-mail and
deliver it to recipients configured on the Switch. This can benefit the Switch administrator by simplifying the
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 9-28 DNS Resolver Dynamic Host Name Table window
Figure 9-29 PPPoE Circuit ID Insertion Settings window
Description
Click the radio buttons to enable or disable the PPPoE circuit ID insertion on the Switch.
Use the drop-down menus to select a range of ports to be configured.
Use the drop-down menu to enable or disable port's PPPoE circuit ID insertion function.
Use the drop-down menu to select the device ID part for encoding of the circuit ID option.
293