Ntp Key Settings; Ntp Interface Settings - D-Link DGS-3000 Series Reference Manual

NTP Key Settings

This window is used to view and configure the NTP key settings.
To view the following window, click Management > NTP > NTP Key Settings, as shown below:
The fields that can be configured are described below:
Parameter
NTP Control Key (1-
255)
NTP Request Key (1-
255)
Key ID (1-255)
MD5
Click the Apply button to accept the changes made.
Click the Trust button to trust the NTP key to authenticate.
Click the Delete button to remove the specific entry.

NTP Interface Settings

This window is used to view and configure the NTP interface settings.
To view the following window, click Management > NTP > NTP Interface Settings, as shown below:
After clicking the Edit button, the following window will appear:
The fields that can be configured are described below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 3-55 NTP Key Settings window
Description
Clear the None check box and enter the NTP control key. Select the None check box
to not use an NTP control key.
Clear the None check box and enter the NTP request key. Select the None check box
to not use an NTP request key.
Enter the NTP key ID.
Enter the MD5 NTP key here. This key can be up to 32 characters long.
Figure 3-56 NTP Interface Settings window
Figure 3-57 CFM MEP Information - Edit Window
69