Ntp Settings; Ntp Global Settings - D-Link DGS-3000 Series Reference Manual

The fields that can be configured are described below:
Parameter
Reset Button Reboot
State
Reset Button ZTP State
Reset Button Factory
State
Click the Apply button to accept the changes made.

NTP Settings

NTP Global Settings

This window is used to view and configure the Network Time Protocol (NTP) global settings.
To view the following window, click Management > NTP > NTP Global Settings, as shown below:
The fields that can be configured are described below:
Parameter
NTP State
NTP Authentication
State
NTP Update Calendar
NTP Master Stratum (1-
15)
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 3-50 ZTP Settings window
Description
Click to enable or disable the reboot state of the reset button on the Switch. When
enabled, pressing the reset button on the Switch within 5 seconds will reboot the
Switch.
Click to enable or disable the ZTP state of the reset button on the Switch. When
enabled, pressing the reset button on the Switch between 5 and 10 seconds will initiate
ZTP.
Click to enable or disable the factory reset state of the reset button on the Switch.
When enabled, pressing the reset button on the Switch more than 10 seconds will reset
the Switch to factory defaults.
Figure 3-51 NTP Global Settings window
Description
Click to enable or disable the NTP global state.
Click to enable or disable the NTP authentication state.
Click to enable or disable the NTP update calendar state.
Enter the NTP master stratum value here. Select the Default check box to use the
default value.
66