D-Link DGS-3000 Series Reference Manual page 91

Hide thumbs Also See for DGS-3000 Series:
Table of Contents

Advertisement

NOTE: The Leave Time value should be greater than twice the Join Time value. The Leave All Time
value should be greater than the Leave Time value.
GVRP Port Settings
On this page the user can configure the GVRP port parameters.
To view the following window, click L2 Features > VLAN > GVRP > GVRP Port Settings as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
PVID (1-4094)
GVRP
Ingress Checking
Acceptable Frame Type
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 4-11 GVRP Port Settings window
Description
Select the starting and ending ports to use.
This field is used to manually assign a PVID to a VLAN. The Switch's default is to
assign all ports to the default VLAN with a VID of 1.The PVID is used by the port to
tag outgoing, untagged packets, and to make filtering decisions about incoming
packets. If the port is specified to accept only tagged frames - as tagging, and an
untagged packet is forwarded to the port for transmission, the port will add an 802.1Q
tag using the PVID to write the VID in the tag. When the packet arrives at its
destination, the receiving device will use the PVID to make VLAN forwarding
decisions. If the port receives a packet, and Ingress filtering is Enabled, the port will
compare the VID of the incoming packet to its PVID. If the two are unequal, the port
will drop the packet. If the two are equal, the port will receive the packet.
The GARP VLAN Registration Protocol (GVRP) enables the port to dynamically
become a member of a VLAN. GVRP is Disabled by default.
This drop-down menu allows the user to enable the port to compare the VID tag of an
incoming packet with the port VLAN membership. If enable ingress checking and the
reception port is not the member port of the frame's VLAN, the frame shall be
discarded.
This field denotes the type of frame that will be accepted by the port. The user may
choose between Tagged Only, which means only VLAN tagged frames will be
accepted, and All, which mean both tagged and untagged frames will be accepted. All
82

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents