Http/Https; D-Link Discovery Protocol - D-Link DGS-1100-16 Reference Manual

HTTP/HTTPS

This window is used to configure Web settings on the Switch.
To view the following window, click Management > HTTP/HTTPS, as shown below:
The fields that can be configured for HTTP/HTTPS Settings are described below:
Parameter
Web Session
Web Session Timeout
Click the Apply button to accept the changes made.
Note: If the switch is in HTTPS mode, the firmware or configuration cannot be upgraded using
regular HTTP.

D-Link Discovery Protocol

This window is used to configure and display D-Link Discovery Protocol (DDP).
To view the following window, click Management > D-Link Discovery Protocol, as shown below:
The fields that can be configured for D-Link Discovery Protocol are described below:
Parameter
D-Link Discovery Protocol
State
Report Timer
Click the Apply button to accept the changes made.
Figure 6-5 HTTP/HTTPS window
Description
Select this option to enable the configuration through HTTP
or HTTPS.
Note: When switching from HTTP to HTTPS mode, the
switch will take about 30 seconds to initialize the secured
HTTP environment.
Enter a value for the amount of time in seconds before the
web session expires.
Figure 6-6 D-Link Discovery Protocol window
Description
Select this option to enable or disable DDP global state.
Select the interval in seconds between two consecutive DDP
report messages. Options to choose from are 30, 60, 90,120,
and Never.
D-Link DGS-1100 Series Switch User Manual
3 3 5 5