D-Link DGS-3000 Series Reference Manual page 345

The user may click the Infinite times radio button, in the Repeat Pinging for field, which will tell the ping program to
keep sending ICMP Echo packets to the specified IP address until the program is stopped. The user may opt to
choose a specific number of times to ping the Target IP Address by clicking its radio button and entering a number
between 1 and 255.
The fields that can be configured are described below:
Parameter
Target IPv4 Address
Target IPv6 Address
Interface Name
Domain Name
Repeat Pinging for
Size
Timeout
Click the Start button to initiate the Ping Test.
After clicking the Start button, the following window will appear:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 11-24 Ping Test window
Description
Click and enter an IP address to be pinged.
Click and enter an IPv6 address to be pinged.
Enter the IPv6 interface name here if the IPv6 address is a link-local or multicast
address.
Click and enter the domain name of the host.
Click and enter the number of times desired to attempt to Ping either the IPv4 address
or the IPv6 address configured in this window. Users may enter a number of times
between 1 and 255.
For IPv6 only, enter a value between 1 and 6000. The default is 100.
Select a timeout period between 1 and 99 seconds for this Ping message to reach its
destination. If the packet fails to find the IP address in this specified time, the Ping
packet will be dropped.
336