Ipv6 Static/Default Route Settings - D-Link DGS-3000 Series Reference Manual

The fields that can be configured are described below:
Parameter
Network Address
IP Address
Click the Find button to locate a specific entry based on the information entered.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.

IPv6 Static/Default Route Settings

A static entry of an IPv6 address can be entered into the Switch's routing table for IPv6 formatted addresses.
To view the following window, click L3 Features > IPv6 Static/Default Route Settings as shown below:
The fields that can be configured are described below:
Parameter
IPv6 Address/Prefix
Length
Interface Name
Nexthop Address
Metric (1-65535)
Backup State
Click the Apply button to accept the changes made.
Click the Delete All button to remove all the entries listed.
Click the Delete button to delete the corresponding entry.
Enter a page number and click the Go button to navigate to a specific page when multiple pages exist.
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 5-2 IPv4 Route Table window
Description
Click the radio button and enter the destination network address of the route to be
displayed.
Click the radio button and enter the destination IP address of the route to be displayed.
Figure 5-3 IPv6 Static/Default Route Settings window
Description
This field allows the entry of an IPv6 address to be assigned to the static route. Select
the Default check box to assign to the default route.
The IP Interface where the static IPv6 route is created.
The corresponding IPv6 address for the next hop Gateway address in IPv6 format.
The metric of the IPv6 interface entered into the table representing the number of
routers between the Switch and the IPv6 address above. Metric values allowed are
between 1 and 65535.
Select the route as the primary or backup route to the destination.
153