Chapter 10 Oam; Cfm; Cfm Settings - D-Link DGS-3000 Series Reference Manual

Chapter 10

CFM

Ethernet OAM
DULD Settings
Cable Diagnostics
CFM

CFM Settings

This window is used to configure the CFM parameters.
To view this window, click OAM > CFM > CFM Settings as shown below:
The fields that can be configured are described below:
Parameter
CFM State
All MPs Reply LTRs
MD
MD Index
Level
MIP
SenderID TLV
Click the Apply button to accept the changes made for each individual section.
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
OAM
Figure 10-1 CFM Settings Window
Description
Click to enable or disable the CFM feature.
Click to enable or disable all MPs to reply LTRs.
Enter the maintenance domain name.
Specify the maintenance domain index used.
Use the drop-down menu to select the maintenance domain level.
This is the control creations of MIPs.
None – Don't create MIPs. This is the default value.
Auto – MIPs can always be created on any ports in this MD, if that port is not configured
with a MEP of this MD. For the intermediate switch in a MA, the setting must be auto in
order for the MIPs to be created on this device.
Explicit – MIPs can be created on any ports in this MD, only if the next existent lower level
has a MEP configured on that port, and that port is not configured with a MEP of this MD.
This is the control transmission of the SenderID TLV.
None – Don't transmit sender ID TLV. This is the default value.
Chassis – Transmit sender ID TLV with chassis ID information.
Manage – Transmit sender ID TLV with managed address information.
Chassis Manage – Transmit sender ID TLV with chassis ID information and manage
address information.
301