Power Saving Mode
Hibernation State
Action
Time Range Name
Click the Apply button to accept the changes made for each individual section.
Click the Clear Time Range to remove all the entries.
Power Saving LED Settings
This window is used to add or delete the power saving schedule on the LED of all ports.
To view the following window, click Management > Power Saving > Power Saving LED Settings, as shown below:
The fields that can be configured are described below:
Parameter
Action
Time Range Name
Click the Apply button to accept the changes made for each individual section.
Click the Clear Time Range to remove all the entries.
Power Saving Port Settings
This window is used to add or delete the power saving schedule on the port.
To view the following window, click Management > Power Saving > Power Saving Port Settings, as shown below:
The fields that can be configured are described below:
Parameter
From Port / To Port
Action
Time Range Name
Click the Apply button to accept the changes made for each individual section.
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Click the radio buttons to enable or disable hibernation state. When enabled, the Switch
will go into a low power state and be idle during the configured time range. It will shut
down all the ports, all network function (telnet, ping, etc.) will not work, and only the
console connection will work via the RS232 port. If the Switch is an endpoint type PSE
(Power Sourcing Equipment), it will not provide power to the port.
Use the drop down menu to add or delete the schedule.
Specify the name of the schedule.
Figure 3-47 Power Saving LED Settings window
Description
Use the drop down menu to add or delete the schedule.
Specify the name of the schedule.
Figure 3-48 Power Saving Port Settings
Description
Select the appropriate port range used for the configuration.
Use the drop down menu to add or delete the schedule.
Specify the name of the schedule.
64