Sflow - D-Link DGS-3000 Series Reference Manual

The fields that can be configured are described below:
Parameter
RSPAN State
VLAN Name
VID (1-4094)
Click the Apply button to accept the changes made.
Click the Add button to add a new entry based on the information entered.
Click the Modify button to re-configure the specific entry.
Click the Delete button to remove the specific entry.
After clicking the Modify button, the following window will appear:
The fields that can be configured are described below:
Parameter
Source
Redirect Port List
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.

sFlow

sFlow (RFC3176) is a technology for monitoring traffic in data networks containing switches and routers. The sFlow
monitoring system consists of an sFlow Agent (embedded in a switch or router or in a standalone probe) and a central
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Figure 11-18 RSPAN Settings window
Description
Click the radio buttons to enable or disable the RSPAN feature.
Create the RSPAN VLAN by VLAN name.
Create the RSPAN VLAN by VLAN ID.
Figure 11-19 RSPAN Settings - Modify window
Description
PortList: Click and enter the ports that should be included.
Group ID: Click and select the group ID that should be included.
If not specified by option, the source of RSPAN will come from the source specified by
the mirror command or the flow-based source specified by an ACL. If no parameter is
specified for source, it deletes the configured source parameters.
Select RX, TX or Both to specify in which direction the packets will be monitored. Click
Add or Delete to add or delete source ports.
Specify the output port list for the RSPAN VLAN packets. If the redirect port is a Link
Aggregation port, the Link Aggregation behavior will apply to the RSPAN packets. Click
Add or Delete to add or delete redirect ports.
332