Impb Port Settings - D-Link DGS-3000 Series Reference Manual

Parameter
Roaming State
Trap / Log
DHCP Snooping (IPv4)
DHCP Snooping (IPv6)
ND Snooping
DHCP-PD Snooping
Recover Learning Ports
File Name
Click the Download button to download the DHCP snooping binding entries from the local PC using HTTP.
Click the Upload button to upload the DHCP snooping binding entries to the local PC using HTTP. Wait for the web
browser to prompt where to save the file on the local PC.
Click the Apply button to accept the changes made for each individual section.

IMPB Port Settings

Select a port or a range of ports with the From Port and To Port fields. Enable or disable the port with the State, Allow
Zero IP and Forward DHCP Packet field, and configure the port's Max Entry.
To view this window, click Security > IP-MAC-Port Binding (IMPB) > IMPB Port Settings as shown below:
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Description
Click to enable or disable the IMPB roaming.
Click to enable or disable the sending of trap/log messages for IP-MAC-port binding.
When Enabled, the Switch will send a trap message to the SNMP agent and the
Switch log when an ARP packet is received that doesn't match the IP-MAC-port
binding configuration set on the Switch. The default is Disabled.
Click to enable or disable DHCP snooping (IPv4) for IP-MAC-Port binding. The default
is Disabled.
Click to enable or disable DHCP snooping (IPv6) for IP-MAC-Port binding. The default
is Disabled.
Click to enable or disable enable ND snooping on the Switch. The default is Disabled.
Click to enable or disable enable DHCP-PD snooping. The default is Disabled.
Enter the port numbers used to recover the learning port state. Select the All Ports
check box to apply to all ports.
Click the Browse button to locate the file on the local PC.
Figure 8-27 IMPB Port Settings window
225