D-Link DGS-3000 Series Reference Manual page 118

Proxy Reporting Source
IP
Proxy Reporting State
Querier State
Fast Leave
State
Report Suppression
Data Driven Learning
State
Data Drive Learning
Aged Out
Version
Click the Apply button to accept the changes made.
Click the <<Back button to discard the changes made and return to the previous page.
After clicking the Modify Router Port
The fields that can be configured are described below:
Parameter
Static Router Port
Forbidden Router Port
Dynamic Router Port
Ports
DGS-3000 Series Gigabit Ethernet Switch Web UI Reference Guide
Enter the source IP of proxy reporting integrated report.
Use the drop-down menu to enable or disable the proxy reporting. If enabled, multiple
IGMP reports or leave for a specific (S, G) will be integrated into one report only
before sending to the router port.
Specify to enable or disable the querier state.
Enable or disable the IGMP snooping fast leave function. If enabled, the membership
is immediately removed when the system receive the IGMP leave message.
If the state is Enabled, it allows the Switch to be selected as an IGMP querier (sends
IGMP query packets). It the state is disabled, then the switch cannot play the role as
a querier.
NOTE: that if the Layer 3 router connected to the switch provides only the IGMP
proxy function but does not provide the multicast routing function, then this state must
be configured as disabled. Otherwise, if the Layer 3 router is not selected as the
querier, it will not send the IGMP query packet. Since it will not also send the
multicast-routing protocol packet, the port will be timed out as a router port.
When enabled, multiple IGMP reports or leave for a specific (S, G) will be integrated
into one report only before sending to the router port.
Specify to enable or disable the data driven learning state.
Specify to enable or disable the data drive learning aged out option.
Specify the version of the IGMP general query sent by the Switch.
link, the following window will appear:
Figure 4-45 IGMP Snooping Router Port Settings window
Description
This section is used to designate a range of ports as being connected to multicast-
enabled routers. This will ensure that all packets with such a router as its destination
will reach the multicast-enabled router regardless of the protocol.
This section is used to designate a range of ports as being not connected to multicast-
enabled routers. This ensures that the forbidden router port will not propagate routing
packets out.
Displays router ports that have been dynamically configured.
Select the appropriate ports individually to include them in the Router Port
109