Rear Panel
USB
This connector lets you connect the MV-8800 to your
computer to transfer files.
FOOT SWITCH
You can connect a separately sold foot switch (e.g.,
Roland DP-2, BOSS FS-5U) here, and use it to control the
MV-8800 in a variety of ways.
OUTPUT DIGITAL A, B
These are digital audio output connectors. "A" is a coaxial
type connector, and "B" is an optical type connector. You
can switch these to output either the master out audio or
the audio from the MULTI OUTPUT bus.
●
The DIGITAL OUT jacks support IEC60958 (consumer).
OUTPUT PHONES
You can connect a set of headphones here.
OUTPUT MASTER
These are the analog master output jacks. Connect them
to your playback system or powered monitor speakers.
ANALOG INPUT MIC/LINE
These are analog input jacks. You can connect
microphones or line-level devices here.
ANALOG INPUT PHONO
You can connect a turntable (record player) to these
jacks.
●
The PHONO jacks provide a PHONO equalizer.
●
If you use the MIC/LINE jacks, you cannot use the PHONO
jacks simultaneously.
●
If you're not using the PHONO jacks, insert the included
short pin. This will prevent noise from being introduced via
the PHONO jacks.
Grounding terminal
Use this if you've connected a turntable. By connecting
this to the grounding wire ("earth") of your turntable you
can reduce the hum or buzz that may otherwise occur.
Panel descriptions
M-23
MV-8800 Owner's Manual