V-Link Function Chart - Roland MV-8800 Owner's Manual

Using the MV-8800 to operate an external V-LINK device (V-LINK Master)
3.
Specify the MIDI transmit channel and other parameters as desired.
For details on the function of these parameters, refer to "V-LINK screen" (Screen Guide; p. 179).

V-LINK Function chart

When V-LINK function is on, you can use the following functions.
Functions preceded by an indication of "MD:" are MD-P1 functions.
V-LINK function
Changing Clip
Changing Clip Bank
Disolve Time
Color Cb Ctrl
Color Cr Ctrl
Brightness Ctrl
VFX1 Ctrl
VFX2 Ctrl
VFX3 Ctrl
VFX4 Ctrl
Fade Ctrl
MD:ColorEQ Fore
MD:ColorEQ Back
MD:Speed Knob
MD:Total Fader
MD:Cross Fader
MD:Assign Knob
MD:Visual Knob
MD:Total Select
MD:FX Select
MD:Play Pos
MD:LoopStartPos
MD:LoopEndPos
MD:LayerModeSel
●
The MV-8800 does not support the Edirol PR-50's Dual Stream mode.
●
The MV-8800 does not support the MD-P1's section B and MIDI Note plug-in control.
●
For the Control Ch parameter, select the MIDI connector to which your V-LINK device is connected.
●
You can change the transmitted MIDI message used by sliders. For details refer to "V-LINK screen" (Screen
Guide; p. 179).
●
You use [PAD BANK] to switch banks, a CC 00 message and Program Change are successively transmitted
when you strike a velocity pad.
●
When switching palettes, the range of selectable banks will depend on the type of the current track (audio track,
MIDI track, and pattern track).
●
Please also read the owner's manual of the V-LINK device you are using.
Uses controller Transmitted MIDI message
Velocity Pads Program change: 00H-0FH
[PAD BANKS] CC 00 (Bank select):
Slider CC 05 (Porta Time)
Slider CC 70 (SoundCtrl 1)
Slider CC 73 (Attack Tm)
Slider CC 75 (Decay Tm)
Slider CC 76 (Vib Rate)
Slider CC 77 (Vib Depth)
Slider CC 78 (Vin Decay)
Slider CC 79 (SoundCtrl10)
Slider CC 95 (Phaser)
Slider CC 01 (Modulation)
Slider CC 71 (Resonance)
Slider CC 08 (Balance)
Slider CC 10 (Pan)
Slider CC 11 (Expression)
Slider CC 72 (Release Tm)
Slider CC 74 (Cutoff)
Slider CC 85
Slider CC 86
Slider CC 91 (Reverb)
Slider CC 92 (Tremolo)
Slider CC 93 (Chorus)
Slider CC 94 (Celeste)
00H-1FH (Audio track)
00H-05H (MIDI track)
00H-07H (Pattern track)
MV-8800 Owner's Manual
20
M-313