5-Creating A Patch; Making A Patch Settings - Roland MV-8800 Owner's Manual

Chapter 5
Creating a patch

Making a patch settings

1.
Press [INSTRUMENTS].
The INSTRUMENTS screen (Screen Guide; p. 114) will appear.
2.
Use CURSOR [ ] [
The selected part number (the current part) will be highlighted.
3.
Press [F5](Patch Edit).
The PATCH EDIT screen (Screen Guide; p. 118) will appear.
1
7 8 9
●
For details on the parameters, refer to "PATCH EDIT screen" (Screen Guide; p. 118).
●
Strike the pads to hear the result of your settings. To check the pads to which the sounds are assigned, press
[PAD BANKS] to display the "PAD BANKS popup" (p. 5).
Part number/Patch name
1
Selects the part that use the patch you want to edit.
2
2 Patch Coarse Tune
Adjust the pitch of the entire patch in steps of one semitone.
Patch Fine Tune
3
Adjust the pitch of entire patch in steps of one cent.
●
One cent = 1/100th of a semitone
Analog Feel Depth
4
Applies irregularity to the patch, simulating the natural instability that is typical of an analog synthesizer.
Pitch Bend Range Down
5
Specifies the amount by which the pitch of the patch will change (in semitones) when you operate the pitch
bender downward.
] to select the part that uses the patch you want to edit.
2 3 4 5 6
10 11 12
M-95
MV-8800 Owner's Manual
5