Turning Off The Power - Roland MV-8800 Owner's Manual

Turning off the power

You must perform the Shutdown operation before turning the power off. The Shutdown operation saves the
stored parameters before powering-off, and safely stops the hard disk.
If you turn off the power without performing Shutdown, or if you turn off the power
before "You May Turn Off." is displayed, the data and the MV-8800 itself will be
damaged. Roland will accept no responsibility for any damage that results from your
failure to perform the Shutdown operation.
1.
Press [SHUTDWON].
A message of "SHUTDOWN Are you sure?" will appear.
2.
Press [F5](Yes).
A message of "Save Current Project before SHUTDOWN?" will appear.
●
If the Project Protect setting is turned on for the current project, the message in step 2 will not appear.
3.
Press [F5](Yes).
The current project will save. When save process is completed, the "SHUTDOWN Completed. You May Turn
Off." message will appear.
●
If you press [EXIT] in step 3, shutdown will be cancelled. If you want to shutdown without saving the current
project, press [F1](No).
4.
Turn down the volume of all connected equipment
5.
Turn off the rear panel POWER ON switch.
Make sure that the "You May Turn Off." message is displayed before you turn off the power.
If you need to turn off the power completely, first turn off the POWER switch, then unplug the power cord from
the power outlet. Refer to "Power Supply" (p. 6).
●
When you turn off the power, you may hear a sound even though the MASTER knob is turned down; this is not
a malfunction.
●
While the Shutdown process is occurring, system parameters and project data is being saved. This will require
a certain amount of time before the MV-8800 is ready for you to turn off the power.
Turning on the power
M-29
MV-8800 Owner's Manual