Table of Contents
Advertisement
Editing events individually
Editing a system exclusive message
1.
Access the EVENT LIST screen as described in "Event list editing" (p. 181).
2.
Use CURSOR [
want to edit.
●
When you use CURSOR [
transmitted from the MIDI OUT connector.
3.
Press CURSOR [
The SYS-EX popup (Screen Guide; p. 27) will appear.
4.
Use CURSOR [
The cursor will move to successive bytes of the exclusive data.
5.
Use the VALUE dial or [DEC] [INC] to edit the value.
If you want to add a data byte to the exclusive message, move the cursor to the desired location and press
[F2](Insert). A value of "00" will be inserted; edit the value as desired.
If you want to delete a data byte from the exclusive message, move the cursor to that location and press
[F3](Delete).
●
To specify the value of a parameter, you can use the VALUE dial or [DEC] [INC], or use the numeric keys to
input the value directly. After using the numeric keys to input a value, press [ENTER] to finalize the input.
6.
When you have finished editing, press [F5](Execute).
The system exclusive message you edited will be finalized.
●
If you decide to stop editing a system exclusive message and discard the changes you made, press [EXIT] to
return to the EVENT LIST screen.
●
When you are inputting a Roland system exclusive message, you can use Auto Check Sum to calculate the
checksum automatically. If Auto Sum is On, the data byte preceding the end of the message (F7) will be the
checksum; the calculated result will be inserted here automatically. If input is not successful, turn Auto Sum "Off"
and then "On" again.
●
If you press [F4](Test), the system exclusive message you're editing will be transmitted from the MIDI OUT
connector.
M-184
MV-8800 Owner's Manual
] [
] or the VALUE dial to move to the system exclusive message you
] [
] to move the current time, the note event located at that time will be
].
] [
] to move the cursor to the data you want to edit.
Advertisement
Table of Contents
