Configuring Snmp User - ZyXEL Communications GS1920 series User Manual

The following table describes the labels in this screen.
Table 155 Management > Access Control > SNMP > Trap Group > Port
LABEL
Option
Port
*
Active
Apply
Cancel

38.3.3 Configuring SNMP User

From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 230 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Table 156 Management > Access Control > SNMP > User
LABEL
User Information
Username
Chapter 38 Access Control
DESCRIPTION
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the trap type of SNMP traps on this port.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Specify the username of a login account on the Switch.
GS1920 Series User's Guide
312