Changing The Clock Setting Using The Cli; Figure 50 Atm Tab - Nortel Passport Module 8672A Using Manual

Figure 50 ATM tab

Table 9 on page 60
4 To set the clock setting, in the ClockSource section, click loopTimed or
freeRunning.
5 Click Apply.

Changing the clock setting using the CLI

To change the clock setting using the CLI, enter:
config atm < ports > clock-source <loop-timed|free-running>
See "config atm command" on page
Chapter 6 Configuring the Passport 8672ATM Module
describes the ATM tab fields.
78.
Using the Passport 8672ATM Module
117