Configuring Mld Ssm Mappings; Configuration Prerequisites; Configuration Procedure; Configuring Mld Proxying - HP VSR1000 Configuration Manual

Step
Enter system view.
1.
Enter interface view.
2.
Enable fast-leave
3.
processing.

Configuring MLD SSM mappings

This feature enables the device to provide SSM services for MLDv1 hosts.
This feature does not process MLDv2 messages. As a best practice, enable MLDv2 on the
receiver-side interface to avoid MLDv2 hosts failing to join IPv6 multicast groups.

Configuration prerequisites

Before you configure MLD SSM mappings, complete the following tasks:
•
Configure an IPv6 unicast routing protocol so that all devices in the domain can interoperate at
the network layer.
•
Configure basic MLD features.

Configuration procedure

To configure an MLD SSM mapping:
Step
Enter system view.
1.
Enter MLD view.
2.
Configure an MLD SSM
3.
mapping.

Configuring MLD proxying

This section describes how to configure MLD proxying.
Configuration prerequisites
Before you configure the MLD proxying feature, complete the following tasks:
Configure any IPv6 unicast routing protocol so that all devices in the domain can interoperate at
1.
the network layer.
Determine the router interfaces and host interface based on the network topology.
2.
Enable MLD on the router interfaces.
3.
Command
system-view
interface interface-type
interface-number
mld fast-leave [ group-policy
ipv6-acl-number ]
Command
system-view
mld [ vpn-instance
vpn-instance-name ]
ssm-mapping
ipv6-source-address
ipv6-acl-number
240
Remarks
N/A
N/A
By default, fast-leave processing
is disabled.
Remarks
N/A
N/A
By default, no MLD SSM
mappings exist.