Mld Ssm Mapping Configuration Example - HP VSR1000 Configuration Manual

[RouterB-GigabitEthernet1/0/2] quit
# On Router C, enable IPv6 multicast routing.
<RouterC> system-view
[RouterC] ipv6 multicast routing
[RouterC-mrib6] quit
# Enable MLD on GigabitEthernet 1/0/1.
[RouterC] interface gigabitethernet 1/0/1
[RouterC-GigabitEthernet1/0/1] mld enable
[RouterC-GigabitEthernet1/0/1] quit
# Enable IPv6 PIM-DM on GigabitEthernet 1/0/2.
[RouterC] interface gigabitethernet 1/0/2
[RouterC-GigabitEthernet1/0/2] ipv6 pim dm
[RouterC-GigabitEthernet1/0/2] quit
Configure an IPv6 multicast group policy on Router A so that hosts connected to
4.
GigabitEthernet 1/0/1 can join only IPv6 multicast group FF1E::101.
[RouterA] acl ipv6 basic 2001
[RouterA-acl-ipv6-basic-2001] rule permit source ff1e::101 128
[RouterA-acl-ipv6-basic-2001] quit
[RouterA] interface gigabitethernet 1/0/1
[RouterA-GigabitEthernet1/0/1] mld group-policy 2001
[RouterA-GigabitEthernet1/0/1] quit
Verifying the configuration
# Display MLD information for GigabitEthernet 1/0/1 on Router B.
[RouterB] display mld interface gigabitethernet 1/0/1
GigabitEthernet1/0/1(FE80::200:5EFF:FE66:5100):
MLD is enabled.
MLD version: 1
Query interval for MLD: 125s
Other querier present time for MLD: 255s
Maximum query response time for MLD: 10s
Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
MLD groups reported in total: 1

MLD SSM mapping configuration example

Network requirements
As shown in
•
OSPFv3 runs on the network.
•
The IPv6 PIM-SM domain uses both the ASM model and SSM model for IPv6 multicast delivery.
GigabitEthernet 1/0/3 of Router D acts as the C-BSR and C-RP. The IPv6 SSM group range is
FF3E::/64.
•
MLDv2 runs on GigabitEthernet 1/0/1 of Router D. The receiver host runs MLDv1, and does not
support MLDv2. The receiver host cannot specify multicast sources in its membership reports.
•
Source 1, Source 2, and Source 3 send IPv6 multicast packets to multicast groups in the IPv6
SSM group range.
Configure the MLD SSM mapping feature on Router D so that the receiver host will receive IPv6
multicast data only from Source 1 and Source 3.
Figure 75:
247