Voice Entity Configuration Examples; Voice Entity Configuration Example For Establishing A Voip Call - HP FlexNetwork MSR Series Configuration Manual

Voice entity configuration examples

This section provides voice entity configuration examples.
Voice entity configuration example for establishing a VoIP
call
Network requirements
As shown in
through WAN.
For example, the user of tel. 1 (010-1001) attached to Router A dials 0755-2001, the number of tel. 3
attached to Router B. After the called party picks up the phone, a conversation is established
between two parties.
Figure 6 Network diagram
Configuration procedure
Routing-related configurations are beyond the scope of this example. This example assumes that
Router A and Router B are reachable to each other.
1. Configure Router A:
# Configure the VoIP voice entity to Router B.
<RouterA> system-view
[RouterA] voice-setup
[RouterA-voice] dial-program
[RouterA-voice-dial] entity 0755 voip
[RouterA-voice-dial-entity755] match-template 0755....
[RouterA-voice-dial-entity755] address sip ip 2.2.2.2
[RouterA-voice-dial-entity755] quit
# Configure the POTS voice entity corresponding to the local interface Line 1/0.
[RouterA-voice-dial] entity 1001 pots
[RouterA-voice-dial-entity1001] match-template 0101001
[RouterA-voice-dial-entity1001] line 1/0
[RouterA-voice-dial-entity1001] quit
# Configure the POTS voice entity corresponding to the local interface Line 1/1.
[RouterA-voice-dial] entity 1002 pots
[RouterA-voice-dial-entity1002] match-template 0101002
[RouterA-voice-dial-entity1002] line 1/1
Figure 6, two voice gateways (Router A and Router B) communicate with each other
26