Replacing The T640 Console Or Auxiliary Cable - Juniper T640 Hardware Manual

Replacing the T640 Console or Auxiliary Cable

Copyright © 2017, Juniper Networks, Inc.
To use a system console to configure and manage the Routing Engine, connect it to the
appropriate port on the CIP. To use a laptop, modem, or other auxiliary device,
CONSOLE
connect it to the appropriate
an RJ-45 connector. One RJ-45/DB-9 cable is provided with the router. If you want to
connect a device to both ports, you must supply another cable.
To connect a management console or auxiliary device:
Plug one end of the replacement cable into the appropriate
1.
port. Figure 120 on page 274
labeled HOST 0 connect to the Routing Engine in the upper Routing Engine slot (
and the ports labeled
HOST 1
Engine slot ( RE1 ).
Plug the other end of the cable into the device's serial port.
2.
Chapter 25: Replacing Chassis Components
port on the CIP. Both ports accept a cable with
AUXILIARY
shows the external device ports on the CIP. The ports
connect to the Routing Engine in the lower Routing
or
CONSOLE AUXILIARY
RE0 ),
273