Replacing The T640 Management Ethernet Cable - Juniper T640 Hardware Manual

Replacing the T640 Management Ethernet Cable

Copyright © 2017, Juniper Networks, Inc.
To replace the management Ethernet cable:
Press the tab on the connector and pull the connector straight out of the
1.
port. Figure 121 on page 276
Disconnect the cable from the network device.
2.
Plug one end of the replacement cable into the appropriate
3.
labeled connect to the Routing Engine in the upper Routing Engine slot (
HOST 0
and the ports labeled HOST 1
Engine slot ( ).
RE1
Plug the other end of the cable into the network device.
4.
Chapter 25: Replacing Chassis Components
shows the connector.
connect to the Routing Engine in the lower Routing
ETHERNET
port. The ports
ETHERNET
),
RE0
275