Removing the Craft Interface
Figure 136: Removing the Craft Interface
Copyright © 2017, Juniper Networks, Inc.
Figure 135: Removing a Standard Upper Front Fan Tray
The craft interface is located on the front of the chassis above the FPC card cage. The
craft interface is hot-removable. To remove the craft interface (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Completely loosen the screws at the four corners of the craft interface.
2.
Insert the blade of a flat-blade screwdriver into the slot on one side of the craft
3.
interface, then gently pry that side out from the chassis.
Repeat Step
3
for the other side of the craft interface.
4.
Grasp the craft interface by the top and bottom edges and carefully pull it straight
5.
out of the chassis.
Remove the Craft Interface Panel by loosening the four fasteners.
6.
Chapter 26: Replacing Cooling System Components
Figure 136 on page
295):
295